Fuji Xerox ApeosPort 450 I

11 System Settings
268
System Settings
11
Control Panel Select Tone
Select the sound to be made when a button displayed on the screen is correctly
selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Control Panel Alert Tone
Select the sound to be made when a button that cannot be selected is selected, or an
error occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for
example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Copy Job Complete Tone
Select the sound to be made when a copy completes normally.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Non-Copy Job Complete Tone
Select the sound to be made when a job other than copying completes.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Fault Tone
Select the sound to be made when an error termination occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Alert Tone
Select the sound to be made when a fault such as a paper jam occurs, and the fault is
left unattended to.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Out of Paper Warning Tone
Select the sound to be made when a job is suspended due to running out of paper in a
tray.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].
Low Toner Alert Tone
Select the sound to be made when the toner cartridge needs to be replaced.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound,
select [Off].