Stapler Faults
525
Problem Solving
16
Stapler Faults
The following describes how to solve stapler problems that may occur when the finisher
(optional) is installed.
Follow the procedures on the following pages if copies are not stapled or staples are
bent. Contact our Customer Support Center if the problem persists after you have tried
the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support
Center.
Unstapled
Bent staple
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with
center pressed in
To Next Page
Loading...
Need help?
General
