17 Appendix
532
Appendix
17
Specifications
This sections lists the main specifications of the machine. Note that the specifications
and the appearance of the product may change without prior notice.
îš„ApeosPort 550 I/450 I/350 I, DocuCentre 550 I/450 I (Copier) Specifications
Type Console
Copying method Laser xerography
Scan resolution 600 x 600 dpi (23.6 x 23.6 dots/mm)
Output resolution 600 x 600 dpi (23.6 x 23.6 dots/mm)
Color gradation 256 gradations
Warm-up time
DocuCentre 550 I/450 I (copier-only model):
Within 30 seconds (at 20 C
°
room temperature)
ApeosPort 550 I/450 I/350 I:
Within 35 seconds (at 22 C
°
room temperature)
Important• The values may vary depending on the machine
configuration.
Document size Maximum: 297 x 432 mm (A3, 11 x 17") for both single sheet
paper and book
Development method Dry development (dual component)
Document table type Fixed
Photosensitive type OPC
Fusing system Heat roller
Scanning method Flatbed scanning using CCD image sensor
Copy paper size Maximum : A3, 11 x 17"
Minimum : A5 (postcard when Tray 5 (Bypass) is used)
Image loss: lead edge - 4 mm or less, trail edge - 4 mm or less,
front/back - 4 mm or less
Copy paper Tray 1 : 60 - 105 g/m
2
Trays 2 to 4 : 60 - 216 g/m
2
Tray 5 (Bypass): 60 - 216 g/m
2
Tray 6 : 56 - 216 g/m
2
Important• The use of paper recommended by Fuji Xerox is suggested.
Depending on the usage of paper, copying may not be
performed properly.
First copy output time <When document glass is used> 3.2 seconds (A4 )
<When document feeder is used> 4.1 seconds (A4 )
Important• The values may vary depending on the machine
configuration.
Magnification Size-for-size 1:1 ± 0.7%
Preset % 1:0.500, 1:0.707, 1:0.816, 1:0.866, 1:1.154,
1:1.225, 1:1.414
Variable % 1:1:0.25-1:4.00 (1% increments)
To Next Page
Loading...
Need help?
General
