Replacing Consumables
433
Maintenance
15
9 Return the staple cartridge holder
to its original position by pushing it
in until it clicks into place.
10 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher
is not completely closed.
Replacing the Staple Cartridge
(When a C Finisher/C Booklet Finisher is Installed)
When a C Finisher (optional) is installed and it is time to replace the staple cartridge, a
message appears on the touch screen. When this message appears, load a new staple
case into the staple cartridge.
The following shows the procedure for replacing the staple cartridge when a C Booklet
Finisher installed. The procedure is also the same on the machine with a C Finisher
installed.
Important • Use of staples not recommended by Fuji Xerox can impair machine performance. Use only
staple cartridges recommended by Fuji Xerox.
Note • To order a new staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not
in operation, and open the front
cover.
2 Hold the staple cartridge holder by
the lever R1, and pull it to the right
towards you.
To Next Page
Loading...
