Changing the Paper Size for the Trays
243
Paper and Other Media
10
5 Move the two paper guides while
holding their grips so that they
lightly contact the edges of the
paper.
Note • When loading standard size
paper in the Tray, move the
paper guides to the marks
corresponding to the paper
size.
6 Push the tray in gently until it comes
to a stop.
Note • Affix the paper size label to the front of the paper tray.
Changing the Paper Size for the Tandem Tray Module
Note • Non-standard size paper cannot be loaded in the tandem tray module.
1 Pull out the tray towards you until it
stops.The elevator in the tray
lowers.
2 Remove any paper loaded on the
tray.
3 Move the paper guide of the tray
towards you to the edge.
4 Load and align the edge of the
paper against the left back corner of the tray with the side to be copied or printed on
face up.
Note • Do not load paper exceeding the maximum fill line. It may cause paper jams or machine
malfunctions.
5 Move the paper guide while holding it to the marks corresponding to the paper size.
6 Push the tray in gently until it comes to a stop.
Note • Affix the paper size label to the front of the paper tray.
Changing the Paper Size for the Tray 6 (High Capacity)
Following describes how to change the paper size for the Tray 6 (high capacity).
1 Pull out the Tray 6 (high capacity)
towards you until it stops.
Important • While the machine processes
a job, do not pull the tray out
that the job uses.
• Do not add new paper to the
paper on the tray in order to
prevent paper jams or making
mistakes of paper loading.
Remove any paper remaining
in the tray and then load the paper on newly loaded paper.
2 Remove any paper loaded on the tray.
To Next Page
Loading...
Need help?
General
