Broadcast
145
Fax
4
Relay Broadcast (Transmitting Documents Through a Relay Station)
The Relay Broadcast feature transmits documents to multiple recipients via other fax
machines (relay stations). When a document is to be transmitted over a long distance
to multiple recipients, it is first transmitted to one relay station and from there to multiple
recipients. When you transmit documents over a long distance to many recipients,
using Relay Broadcast can save on call charges.
Furthermore, multiple Relay Broadcast operations can be performed simultaneously.
This is referred to as Multiple Relay Broadcast.
Note • For information on which machines can be used as initiating stations and relay stations, refer
to "Models Available for Relay Broadcast Send" (P.152).
There are three Relay Broadcast Send methods.
îš„Fax Signal Method
This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that have the Relay Broadcast Send feature. The G3 mode
is available.
îš„DTMF Method
G3 fax machines that support Manual Send can make Relay Broadcasts for the
machine.
îš„F Code Method
This method can be used among machines that have the F Code and the Relay
Broadcast Send features. The G3 mode is available.
Before using the Relay Broadcast Send Feature
Before using the Relay Broadcast Send feature, register the following information in the
address numbers of initiating stations and relay stations.
For information on how to register address numbers, refer to "Address Book (Address Number)"
(P.347).
Where Contents
Initiating
station
Fax Signal Method
Assign the relay station to an address number (001 to 500
*
) to set up the Relay
Broadcast Send feature.
z
Register the last two digits of the address number of the initiating station
(which is already registered at a relay station) as a relay station ID for the
Relay Broadcast Send operation.
z
Register the address numbers or group dial number of the relay recipients
(which are registered at a relay station) as broadcast recipients. The wildcard
"
∗" can be used.
DTMF Method (G3)/F Code Method
z
No registration is required. The dialing format can be registered to an address
number.
To Next Page
Loading...
Need help?
General
