11 System Settings
296
System Settings
11
Port Settings
Set the interface by which the machine is connected to a client. In [Port Settings], you
can set the following items.
For information on port settings, refer to the Network Administrator Guide.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
For information on protocol settings, refer to the Network Administrators Guide.
Machine E-mail Address/Host Name
Set the e-mail address and host name for the machine. In [Machine E-mail Address/
Host Name], you can set the following items.
For information on e-mail address/host name of the machine, refer to the Network Administrator Guide.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items.
For information on POP server settings, refer to the Network Administrator Guide.
1. Parallel 7. Ether Talk 13. Send E-mail
2. USB 8. Salutation 14. Mail Notice Service
3. LPD 9. Port 9100 15. UPnP Discovery
4. NetWare 10. SNMP 16. Internet Service (HTTP)
5. SMB 11. FTP Client 17. SOAP
6. IPP 12. Receive E-mail 18. WebDAV
1. Ethernet Settings 4. TCP/IP - Subnet Mask
2. TCP/IP - Get IP Address 5. TCP/IP - Gateway Address
3. TCP/IP - IP Address 6. TCP/IP - IP Filter
1. E-mail Address
2. Host Name
3. Domain Name
1. POP3 Server Setup 5. POP3 Server Check Interval
2. POP3 Server IP Address 6. POP3 Server Login Name
3. POP3 Server Name 7. POP3 Server Password
4. POP3 Server Port Number 8. POP Password Encryption
To Next Page
Loading...
Need help?
General
