Print Mode Settings
303
System Settings
11
Receiving Buffer - Port 9100
Set the Port 9100 receiving buffer.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
Delete Form
You can delete registered ESC/P forms.
1 Select [Delete Form].
2 Select the print mode to delete
forms.
3 Enter the form number with the
numeric keypad, and select
[Confirm].
4 Check the form name, and select [Delete Data].
îš„ESC/P
Delete ESC/P emulation forms.
îš„Form Number
When you select an item to be deleted, you can enter the form number. Enter the form
number selected from 1 to 64 (when a hard disk is installed, selected from 1 to 2048).
îš„Form Name
After you enter the form number and select [Confirm], the form name matching the
entered number appears.
Other Settings
You can make other settings relating to the paper used in the printer.
1 Select [Other Settings].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to return to the
previous screen or [ ] to move to the next screen.
3 Select the setting value.
4 Select [Save].
Print Area
Set whether to expand the print area.
For information on the printable area, refer to "Printable Area" (P.541).
To Next Page
Loading...
Need help?
General
