11 System Settings
250
System Settings
11
System Settings Procedure
To make or change the system settings, it is necessary to be in the System
Administration mode.
This section describes the basic procedures for system settings. The following shows
the reference section for each procedure.
Step 1 Entering System Administration Mode .........................................................................250
Step 2 Entering the System Administrator User ID and Password...........................................250
Step 3 Selecting the Operation Mode on the System Administrator Menu..............................250
Step 4 Selecting an Item on the [System Settings] Screen .......................................................251
Step 5 Setting the Feature .........................................................................................................252
Step 6 Exiting the System Administration Mode......................................................................252
Step 1 Entering System Administration Mode
1 Press the <Log In/Out> button.
Step 2 Entering the System Administrator User ID and Password
To enter the System Administration mode, enter the system administrator user ID. If
you are using the authentication feature, a password may be required.
It is recommended to change the system administrator user ID and password immediately after installing
the machine. For information on the settings, refer to "System Administrator Settings" (P.357).
1 Enter the user ID with the numeric
keypad or a keyboard displayed by
pressing [Keyboard], and select
[Confirm].
Note • The default user ID is “11111”.
When using the
Authentication feature, a
password is required. The
default password is “x-admin”.
Step 3 Selecting the Operation Mode on the System Administrator Menu
1 Select [System Settings].
123
456
789
0 #
C
<Log In/Out> butto
To Next Page
Loading...
Need help?
General
