Setup Menu
351
System Settings
11
Delayed Start
Set whether or not to use a delayed start transmission.
1 Select [Off] or [On].
2 If you selected [On], select [AM] or
[PM], then set the time with [ ]
and [ ].
If the time in the system clock of the
machine is set to display in the 24-hour clock, [AM] and [PM] do not appear. For information on the
system clock, refer to "Time" (P.265).
Remote Mailbox
Select whether to use mailbox communications. Note that when using mailbox
communications, the other party's mailbox number and password must be set in
advance.
1 Select [Off] or [On].
2 If you selected [On], with the
numeric keypad enter the
recipient's mailbox number, and
select [Next].
3 If a password is set, enter the password with the numeric keypad, and select [Save].
Note • If no password is set, do not input anything, and select [Save].
F Code
Select whether to use F code communications.
F Code is the transmission procedure set by the Communications and Information
Network Association of Japan and is the T.30 (communication protocol) method for using
sub-addresses that was standardized by the ITU-T.
The F code (sub address) and password use not more than 20 digits 0 to 9, ∗, and #.
1 Select [Off] or [On].
2 If you selected [On], with the
numeric keypad enter the F code,
and select [Next].
Note • The F code consists of “0” +
mailbox number. For example, if the mailbox number is 123, the F code is “0123”.
3 Enter the password as required with the numeric keypad, and select [Save].
Note • You can enter up to 20 digits for the password.
To Next Page
Loading...
Need help?
General
