11 System Settings
350
System Settings
11
Relay Station Setup
When the machine is used as a relay station in a relay broadcast, select whether or not
to certify the registered address number as an initiating station for the relay broadcast.
When performing the relay broadcast, the initiating station must be registered to an
address number in the relay station regardless of the instruction method.
Communication Mode
Set the communications mode. You can select from [G3 (Auto)] or [F4800].
When the destination is specified by an address book entry with the communications
mode set, it is not possible to change the communications mode in the [Fax/iFax]
screen.
Note • For iFax, the setting applies to the section between the fax gateway and the recipient fax.
Resolution
Set the image quality in a transmission.
Select from [Panel] (image quality selected on the control panel), [Standard], [Fine],
[Superfine (400 dpi)], and [Superfine (600 dpi)].
Cover Note
Select whether to send transmissions with a cover sheet attached. If attached, specify
comments relating to the recipients and sender to be included in the cover sheets.
Comments must be registered in advance.
For information on comment registration, refer to "Comments" (P.355).
1 [Off] or [On].
2 When [On] is selected, select
[Comment].
3 Select [Recipient's Comment].
4 Select [On], and select a comment
from the displayed list of
comments.
Note • Select [ ] to return to the
previous screen or [ ] to
move to the next screen.
5 Select [Save].
6 To insert a [Sender's Comment], repeat the procedure of Steps 4 and 5.
Maximum Image Size
Select the maximum storage size from [A3], [B4], and [A4], to match the recipient's
paper size or processable profile.
To Next Page
Loading...
Need help?
General
