Login Setup/Auditron Administration
367
System Settings
11
The following items are common settings for each verification feature.
Auditron Mode
Select whether to use the auditron administration feature when using the copy, fax,
scan, and print services. Note that login setup/auditron administration cannot be used
unless the system administrator user ID is set.
For information on the items you can manage, refer to "Authentication and Auditron Administration"
(P.418).
Note • To set the fax charging data, be sure to select [Exit], and exit the System Administration
mode, then once again enter the System Administration mode to make the settings.
• The items appearing depend on the services provided.
1 Select [Auditron Mode].
2 For the services for which you want
to enable the administration
feature, select [On].
îš„Copy Service
Administers operations relating to copying.
îš„Fax Service
Administers operations relating to fax and iFax.
îš„Scan Service
Administers operations relating to scanning.
îš„Print Service
Administers operations relating to printing.
Mailbox Access
Set whether to carry out authentication when printing or retrieving documents stored in
a mailbox.
Note • This item appears when a mailbox is registered.
1 Select [Mailbox Access].
2 Set any item.
îš„Login During Printing
Set whether authentication is required when a document within a mailbox is printed.
îš„Login During Retrieval
Set whether authentication is required when a document within a mailbox is retrieved
through the network.
To Next Page
Loading...
Need help?
General
