11 System Settings
298
System Settings
11
Server - Server Name
Set the server name of the remote authentication server. Up to 255 characters are
allowed.
Note • You can set the server name when [Server - Server Setup] is set to [By Server Name].
Server - Port Number
Set the remote authentication server port number in the range 1 to 65535.
Server - Realm Name
When using an active directory of Windows 2000 Server or Windows Server 2003, set
the domain name of the active directory as a realm name. 64 characters are allowed.
Important • Enter a realm name with a capital letters. Otherwise, an authentication error occurs.
PKI (Public Key) Settings
You can set the HTTP-SSL/TLS and S/MIME.
Note • Before setting the HTTP-SSL/TLS or S/MIME communications, the device certificate must
be set. For information on the device certificate, refer to the Network Administrator Guide.
1 Select [PKI (Public Key) Settings].
2 Select the item to be set.
HTTP - SSL/TLS Settings
Set the HTTP-SSL/TLS.
1 Select the item to be set or
changed, and select [Change
Settings].
2 Set the setting value.
3 Select [Save].
Device Certificate - SSL Server
Select a certificate to be linked.
HTTP - SSL/TLS Communication
Enable or disable the HTTP-SSL/TLS communications.
HTTP - SSL/TLS Port Number
Set the HTTP-SSL/TLS communications port number in the range from 1 to 65535.
S/MIME Settings
Set the S/MIME.
1 Select the item to be set or
changed, and select [Change
Settings].
2 Select the setting value.
3 Select [Save].
To Next Page
Loading...
