Scan Mode Settings
311
System Settings
11
Other Settings
You can make other settings relating to the scanner feature specification.
1 Select [Other Settings].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to return to the
previous screen or [ ] to move to the next screen.
3 Select the setting value.
4 Select [Save].
Scan Service
Set whether or not to use the scanner feature.
Memory Full Procedure
While scanning an original, if there is insufficient hard disk space for the scanner, a
screen appears, asking how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the
subsequent processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.266).
Cancel Job
The stored data is discarded.
Run Job
The read-in data is treated as valid, and the part of the original read in is treated as a
complete stored file.
Maximum Stored Pages
Set the maximum number of stored pages of a scan original. You can set a number
from 1 to 999 pages.
TIFF Format
Set the TIFF format for scanned data. You can select from [TIFF V6] and [TTN2].
Image Transfer Screen
Select whether to display a message when the scan of an original is completed.
Hide Message and Screen
Do not show a scan completion message.
Display Message Only
Show a scan completion message.
Display Message and Screen
Show a screen while original is being scanned, and also a scan completion message.