Scan to FTP/SMB
175
Scan
5
Scan to FTP/SMB
You can convert scanned data to TIFF, DocuWorks, or PDF format, and then use the
FTP or SMB protocol to send the data to a computer on the network. The following
shows the reference section for each feature.
Note • Before scanning, a shared folder must be created on the computer for saving scanned data.
If the FTP protocol is used, the FTP service must be set. For information on the computer
settings, refer to the documentation supplied with your operating system. For information on
compatible operating systems, refer to "ApeosPort 550 I/450 I/350 I, DocuCentre 550 I/450 I
(Scanner) Specifications" (P.536).
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Transfer Protocol...................................................................................................................... 175
Address Book ........................................................................................................................... 176
Specifying a Forwarding Destination....................................................................................... 176
1 Select [Scan to FTP/SMB] on the
[All Services] screen.
2 Specify a forwarding destination on the [Save in] screen.
Note • Fields displayed vary depending on the protocol.
Transfer Protocol
You can select a transfer protocol using the following procedure.
1 Select [Transfer Protocol].
2 Select any item.
îš„FTP
Transfers using the FTP protocol.
îš„SMB
Transfers using the SMB protocol.
îš„SMB (UNC format)
Transfers using the SMB protocol (UNC format).
To Next Page
Loading...
Need help?
General
