Common Settings
267
System Settings
11
Auto Print
Set the period to start the next print job after finishing a copy job.
Set the value from 1 to 240 seconds in 1 second increments. If you select [Off], once
the machine is ready, printing can start immediately.
1 Select [Auto Print], and select
[Change Settings].
2 Select [Off] or [On].
3 If you selected [On], set the time.
Auto Power Saver
In the power saving mode, there is the Low Power mode and Sleep mode, and when
the set time has elapsed, these modes are switched to in the following way, thus
reducing the power consumption.
Last selection on the machine J Low Power mode J Sleep mode
1 Select [Auto Power Saver], and
select [Change Settings].
2 Set the Low Power mode and
Sleep mode.
Note • You cannot set not to switch
to the Low Power mode or the
Sleep mode.
îš„From Last Selection to Low Power Mode
Set the time to change from the last selection to the Low Power mode from 2 to 60
minutes, in 1 minute increments.
Note • Set the time [From Last Selection to Low Power Mode] not to exceed the time [From Last
Selection to Sleep Mode].
îš„From Last Selection to Sleep Mode
Set the time to change from the last selection to the Sleep mode from 2 to 60 minutes,
in 1 minute increments.
Audio Tones
Select whether or not to sound an alarm, for example when a job ends or a fault occurs.
1 Select [Audio Tones].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to return to the
previous screen or [ ] to move to the next screen.
3 Select the setting value.
4 Select [Save].
To Next Page
Loading...
Need help?
General
