11 System Settings
326
System Settings
11
Address Search (Directory Service)
You can set the attributes and ranges for searching address books stored in the
directory server.
Note • This feature only supports the address book used with the e-mail feature.
1 Select [Address Search (Directory
Service.)].
2 Select the item to be set, and
select [Change Settings].
Note • Select [ ] to display the
previous screen and select [ ] to display the next screen.
3 Select the setting value.
4 Select [Save].
Directory Service (LDAP)
Select whether to allow the use of address books stored on the directory server.
z
Even when [Enabled] is selected, unless the following conditions are met, the
address book of the directory server will not be started.
- The IP address must be correctly set
- The directory server (primary) IP address or Internet address must be set
- The port number used for LDAP communications must be set
Primary Server
Make the primary server settings of the directory server.
1 Select [Primary Server].
2 Select the item to be set, and
select [Change Settings].
3 Set the setting value.
îš„Primary Server Setup
Select the primary server specification method from [By IP Address] and [By Server
Name].
îš„Primary Server IP Address
Set the primary server IP address, using values from 0 to 255.
Note • You can set this item when [Primary Server Setup] is [By IP Address].
• 224.XXX.XXX.XXX to 255.XXX.XXX.XXX and 127.XXX.XXX.XXX cannot be set.
îš„Primary Server Name
Set the server name for the primary server. 64 characters are allowed.
Note • You can set this item when [Primary Server Setup] is [By Server Name].
Primary Server Port Number
Set the directory server port number in the range from 1 to 65535.
To Next Page
Loading...
Need help?
General
