Replacing Consumables
431
Maintenance
15
12 Close the Tray 5 (bypass).
13 Close the front cover.
Note • A message will be displayed and the machine will not operate if the front cover is not
completely closed.
Replacing the Staple Cartridge (When a B Finisher is Installed)
When a B Finisher (optional) is installed and it is time to replace the staple cartridge, a
message appears on the touch screen. When this message appears, load a new staple
case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a new staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not
in operation, and open the front
cover of the finisher.
2 Hold the staple cartridge holder by
its lever as shown, and move the
staple cartridge to the right towards
you.
3 Lift up to remove the staple
cartridge holder.
4 Press in both sides of the staple
cartridge holder marked "PUSH".
To Next Page
Loading...
