Power Saver Mode
37
Product Overview
2
Power Saver Mode
The machine is installed with a Power Saver feature that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
The Power Saver feature has two modes: Low Power mode and Sleep mode.
The machine enters the Low Power mode after the preset time has elapsed if the
machine is left unused for a fixed period of time. The machine then enters the Sleep
mode if a further preset time elapses.
îš„Low Power Mode
In this mode, the power to the control panel and fuser unit is lowered to save power.
The touch screen goes out, and the <Power Saver> button on the control panel lights.
To use the machine, press the <Power Saver> button. The
<Power Saver> button goes
out to indicate that the Power Saver feature is canceled.
îš„Sleep Mode
In this mode, the power is lowered more than in the Low Power mode.
The touch screen goes out, and the <Power Saver> button on the control panel lights.
To use the machine, press the <Power Saver> button. The
<Power Saver> button goes
out to indicate that the Power Saver feature is canceled.
Changing the Power Saver Mode Change Interval
The procedure for setting the Power Saver feature is as follows.
To activate the Power Saver feature, set the Sleep Mode button to Enabled, and set
both the times until the activation of Low Power Mode and Sleep Mode.
1 Press the <Log In/Out> button.
2 Enter the User ID with the numeric
keypad, and select [Confirm].
Note • The default User ID is
"11111". When the
Authentication features is in
use, a password may be
required. The default
password is "x-admin".
3 Select [System Settings].
123
456
789
0 #
C
<Log In/Out>
button
To Next Page
Loading...
Need help?
General
