11 System Settings
366
System Settings
11
Off
No user login setup/auditron administration is required to operate the machine.
Note • Even if [Auditron Mode] and [Mailbox Access] are set to [On], this does not feature.
Local Machine Access
The auditron administration is carried out using the authenticated users already registered
on the machine.
For information on authentication on the machine, refer to "Authentication and Auditron
Administration" (P.418).
Network Access
Auditron administration is carried out using user information managed by the remote
accounting service. User information is registered by the remote accounting service.
For information on net authentication, refer to "Authentication and Auditron Administration" (P.418).
Note • When [Network Access] is set in the [Login Setup/Auditron Mode] screen which appears
when the <Log In/Out> button on the control panel is pressed, you can enter the account ID.
îš„Check User Details
Select whether to check user details.
If [Off (Keep logon records)] is selected, [User ID] and [Account ID] must be entered,
but are not checked the user information. However, the entered information is logged
onto the machine. Select [On] to verify user information.
Remote Access
Verifies remote accounting server. Can be used to manage user information managed
on a remote accounting server. User information cannot be registered on the machine.
For more information on remote authentication, refer to "Authentication and Auditron Administration"
(P.418).
Important • When switching to or from the remote access mode, the following information is lost.
- All user information
- Personal mailboxes and personal job flow sheets
• When a Kerberos server is used as a remote authentication server, if the time of the remote
authentication server and that of this machine differs, authentication may fail.
• Remote authentication cannot be used in the following conditions:
- When enabling [TCP/IP - IP Filter] of [Protocol Settings] in [Network Settings] under
[System Settings]
- When enabling [Permitted IP Address] of [IP Address List] in [TCP/IP] under [Protocol
Settings] of [Properties] in CentreWare Internet Services
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
îš„Guest User
Set whether a user not registered with the remote authentication server can use the
machine as a guest user.
îš„Guest Password
Configure the guest password as necessary. You can set the password to from 4 to 12
digits.
To Next Page
Loading...
Need help?
General
