11 System Settings
352
System Settings
11
Relay Broadcast
When the machine is used as a relay station in a relay broadcast, set the specifications
to be send to the relay station when the a registered address book entry is used for the
relay station. When set to [Enabled], set [Relay Station ID], [Broadcast Recipients], and
[Print at Relay Station].
1 For a relay broadcast, select [On],
and select [Save].
2 With the numeric keypad, enter the
relay station ID as two digits, then
select [Enter/Change Recipients].
Note • The relay station ID is the address book number for the relay station (the machine) already
registered as a relay station.
3 With the numeric keypad, enter the
address number (001 to 099) or
group dial number (#01 to #09) for
the broadcast destination, and
select [Add].
Note • If there is more than one
broadcast destination,
continue by entering another
address number or group dial number, and pressing [Add].
4 To print a document also to the relay station, under [Print at Relay Station] select [On].
Billing - Day Time, Billing - Night Time, Billing - Late Night Time
Set the connection time for one unit charge in each of the time bands (daytime/night/
late night).
You can set the value from 0.1 to 255.9 seconds in 0.1 second increments.
This item appears when the fax feature for the Login Setup/Auditron Administration is enabled. For
information on how to enable the feature, refer to "Auditron Mode" (P.367).
The registered details can be confirmed by printing the [Billing Data List]. For information on how to
print, refer to "Billing Data List" (P.398).
1 Insert the card, and enter the
System Administration mode.
For the method to enter the System
Administration mode, refer to "System
Settings Procedure" (P.250).
2 Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight Time],
and select [Change Settings].
3 Select [Not Billing] or [Billing].
4 When [Billing] is selected, using the keyboard displayed on the screen or the numeric
keypad on the control panel, enter the time for one unit charge (0.1 to 255.9 seconds
in 0.1 second increments).
5 Select [Save].
6 Exit the System Administration mode, and remove the card.
To Next Page
Loading...
