Fuji Xerox ApeosPort 450 I User Manual

Print Mode Settings
301
System Settings
11
3 Set the setting value.
4 Select [Save].
Note • When a port is set to [Disabled], the corresponding items do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may
not change the time taken to release the client.
PostScript Memory
Specify the memory capacity used for PostScript.
You can specify the value within the range from 8.00 to 96.00 MB in 0.25 MB
increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
ESC/P Form Memory
Displays destination to save forms used in ESC/P.
IF a hard disk is not installed, data can be stored in the ESC/P form memory. You can
specify the value within the range from 128 to 2048 KB in 32 KB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
HP-GL/2 Auto Layout Memory
Specify the capacity for HP-GL/2 auto layout memory.
IF a hard disk is not installed, data can be stored in the HP-GL/2 auto layout memory.
You can specify the value within the range from 64 to 5120 KB in 32 KB increments.
Note • This feature appears when a emulation kit or PostScript 3 kit is installed.
• The maximum value that can be set varies according to the available memory capacity.
Receiving Buffer - Parallel
Set the parallel receiving buffer.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
Receiving Buffer - USB
Set the receiving buffer for USB.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Receiving Buffer - LPD Spool
Off
Do not use spooling. While LPD print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Set a value for the dedicated LPD receiving buffer memory capacity from 1024 to 2048 KB,
in 32 KB increments.

Fuji Xerox ApeosPort 450 I Specifications

General

Brand	Fuji Xerox
Model	ApeosPort 450 I
Category	Printer
Language	English