13 Machine Status
388
Machine Status
13
Programming
You can check or change the values set for the print mode item numbers.
PDF, PCL, ESC/P and HP-GL2 emulation modes are available for the machine.
For information on KS emulation mode, refer to the User Guide for the Korean model. For information
on the ESCPK emulation mode, refer to the User Guide for the Traditional Chinese model.
1 Select [Programming].
2 Enter the feature number to be set
in [Item Number] using the numeric
keypad.
3 Select [Confirm] as necessary.
4 Select [Change Value].
5 Enter [New Value] using the
numeric keypad.
6 Select [Save].
îš„Item Number
Enter the item number of the feature to be set.
îš„Current Value
When you enter [Item Number], the currently set value appears.
îš„New Value
Enter a new value.
Store/Delete Programming
For ESC/P and HP-GL/2 emulations, you can register print modes in the memory.
You can register up to 20 print modes for ESC/P and HP-GL/2 emulations.
1 Select [Store/Delete
Programming].
2 Select [Store Current Selections] or
[Delete].
3 Select the memory number to be
stored or to be deleted.
îš„Store Current Selections
Stores the current selections. If you select a number already stored, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
îš„Delete
When you select [Delete] and then select the number to be deleted, the number will be
deleted.
Important • The deleted numbers cannot be restored.
To Next Page
Loading...
Need help?
General
