16 Problem Solving
530
Problem Solving
16
3 Hold the left and right tabs on the
booklet staple cartridge to pull the
cartridge out.
4 Remove the jammed staples as
shown in the figure.
5 Hold the tabs on the booklet staple
cartridge to return the cartridge to
the original position, and gently
push the cartridge until you hear it
click into place.
6 Return the unit to its original
position.
7 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate unless the front cover is
completely closed.
If the staples cannot be removed after carrying out the above procedures, contact our
Customer Support Center.
To Next Page
Loading...
Need help?
General
