HP-GL2 Emulation
565
Appendix
17
Active Area
Determining
Command
161 0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for
obtaining the active coordinate area.
[Auto]...Determines any of the methods listed below: PS,
IW, IP, or Adapted.
[PS]…Area specified by the first PS command is to be a
rectangular area.
[IW]...Area specified by the very last IW command is to
be a rectangular area.
[IP]...Area which combines all the IP Commands is to be
a rectangular area.
[Adapted]...The maximum/minimum coordinates within
the areas and coordinates plotted using the drawing
command, and the maximum size of characters and line
width specified in the page, are used to calculate the
rectangular area.
Paper Margin 162 0 to 99 (Default): 0): 0 - 99 mm
Sets the paper margin when auto scaling is being used.
Image
Enhancement
163 0: OFF
1 (Default): ON
Sets whether to artificially increase the resolution of an
image and smooth its edges.
Stapling 164 0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.
Manual Feed Tray
Check Indicator
165 0: None
1 (Default): Yes
Punching 166 0: None
1 (Default): Top
2: Bottom
3: Left
4: Right
Sets the punch position.
Number of holes 167 0 (Default): 2 holes
1: 3 holes
2: 4 holes
To Next Page
Loading...
Need help?
General
