3 Copy
56
Copy
3
When [Preset %] is Selected
You can select a ratio from preset standard copy ratios.
1 Select the copy ratio from [Reduce/
Enlarge].
îš„100%
Copies are made at the same size as the original document.
îš„Auto %
The copy ratio is automatically set based upon the document and paper sizes specified
in [Paper Supply], and the document is copied to fit in the specified paper size.
Note • If you select [Auto %], specify a value other than [Auto] for [Paper Supply].
îš„Presets % (7 types)
Select from 7 preset ratios.
You can change the indicated ratios. For more information on the setting procedures, refer to "Reduce/
Enlarge Presets" (P.294).
îš„Copy All (Full Screen)
The document is copied at a slightly reduced size to prevent image loss at the edge of
the original. If this option is selected, a check mark is added.
Important • If you select [Copy All], when you do not want to erase the edges of the document, set the
amount of edge erase to 0 mm. Note that if the amount is set to 0 mm, the edges of the
copied document may get dirty or the image loss may occur.
When [Variable %] is Selected
You can enter any ratio for copying. Set the ratio within the range from 25 to 400% in
1% increments.
1 Specify the ratio with the numeric
keypad or [ ] and [ ].
Note • If you enter an incorrect value,
press the <C> button.
When [Independent X-Y%] is Selected
You can specify different height and width ratios to scale the height and width
independently.
1 Select any item.
îš„Auto
Copies are made with the height and width ratios set automatically to match the paper
size. If this option is selected, a check mark is added.
To Next Page
Loading...
Need help?
General
