17 Appendix
586
Appendix
17
îš„To print an activity report to check the transmission results
<Machine Status> J [Billing Meter/Print Report] J [Print Report/List] J
J [Job Status/Activity Report] J [Activity Report]
* When [Activity Report] is displayed on the [All Services] screen: [Job Status/Activity Report] J [Activity
Report]
For more information, refer to "Activity Report" (P.393).
îš„To have activity reports not printed automatically
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Common Settings] J [Reports] J [Activity Report] J [Auto Print Off]
For more information, refer to "Activity Report" (P.277).
îš„To change the output destination for incoming faxes
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Fax Mode Settings] J [File Destination/Output Destination] J
J [Output Destination-Line Setup]
For more information, refer to "Output Destination - Line Setup" (P.318).
îš„To change the output paper for incoming faxes
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Fax Mode Settings] J [Fax Control] J [Receiving Paper Size]
For more information, refer to "Receiving Paper Size" (P.316).
îš„To change the volume of the audio tone produced upon fax reception
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Common Settings] J [Audio Tones] J [Ringing Volume]
For more information, refer to "Ringing Volume" (P.269).
îš„To change the number of rings
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Fax Mode Settings] J [Fax Control] J [Auto Switch Attempts]
For more information, refer to "Auto Switch Attempts" (P.316).
îš„To constantly allow mixed size originals to be loaded
<Log In/Out> J Enter the user ID J [System Settings] J [System Settings] J
J [Fax Mode Settings] J [Fax Defaults] J [Mixed Size Originals] J [On]
For more information, refer to "Mixed Size Originals" (P.313).
To Next Page
Loading...
Need help?
General
