3 Copy
96
Copy
3
Delete Outside
Delete the outside of the selected area when copying.
Delete Inside
Delete the inside of the selected area when copying.
Area Settings
The [Delete Outside/Delete Inside - Area 1] screen is displayed when selecting [Area
1].
Refer to "[Delete Outside/Delete Inside - Area 1] screen" (P.96).
Originals
For 2-sided documents, specify the side of the area you want to delete outside of or
inside of.
z
Both Sides
The setting is applied to both sides of the document.
z
Side 1 Only
The setting is applied to only to Side 1 of the document.
z
Side 2 Only
The setting is applied to only to Side 2 of the document.
[Delete Outside/Delete Inside - Area 1] screen
Set the area to delete outside of or inside of. The quadrangle with a diagonal line and
4 straight sides connecting the coordinates, X1/Y1 and X2/Y2 is deleted or extracted
area. By making the top right corner of a document into the starting point, the X-axis is
set as the direction of width, and the Y-axis is set as the direction of length.
You can specify a value of 0 to 432 mm for the width (X) and the length (Y) in 1mm
increments.
Note • Specify the 2 coordinates from the top right corner of the document.
• When [Reduce/Enlarge] is enabled, the specified area will be reduced/enlarged accordingly.
1 Enter the value for X1 in [X1] using
the numeric keypad, and select
[Next].
2 Enter the value for the Y2 in [Y2]
using the numeric keypad, and
select [Next].
3 Enter the value for X2 in [X2] using the numeric keypad, and select [Next].
4 Enter the value for Y2 in [Y2] using the numeric keypad, and select [Next].
Note • To change the coordinates you have entered, select [Next], move , and enter the value
again.
Clear Area 1
Clear the specified area.
Next
the mark moves to the next coordinate.
To Next Page
Loading...
