Fujitsu PRIMERGY RX2540 M6

▶
"Removing the fan cage" on page 74.
Removing the defective 24x 2.5-inch HDD backplane and the switch
board
▶
Disconnect all cables from the switch board.
Figure 89: Removing the 24x 2.5-inch HDD backplane and the switch board
▶
Release the screws (see blue circles).
▶
Pull the HDD backplane upward until the six hooks disengage (see orange
circles).
▶
T
ake out the HDD backplane with the switch board.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M6 Upgrade and Maintenance Manual 185