Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 52
.
▶
"Shutting down the server" on page 52.
▶
"Disconnecting the power cord" on page 53.
Removing the OCP dummy cover
Figure 145: Removing the OCP dummy cover
▶
Loosen the knurled screw (1).
▶
Pull the dummy cover open to release the hook on the left side (2).
▶
Remove the dummy cover (3).
CAUTION
▶
Keep the dummy cover for future use.
▶
If you remove an OCP module and do not immediately replace it
with a new one, a dummy cover must be reinstalled in the bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Expansion cards and backup units
250 Upgrade and Maintenance Manual RX2540 M6
To Next Page
Loading...
