▶
"Removing the air duct" on page 78
.
▶
"Removing the fan cage" on page 74.
▶
"Removing the cross bar" on page 80.
Removing the defective TPM
▶
Remove the TPM, see "Removing the TPM" on page 483.
▶
Leave the TPM spacer on the system board when removing the defective
TPM.
Installing the new TPM
The TPM spacer is already present on the system board.
▶
Install the TPM, see "Installing the TPM" on page 480.
Concluding steps
▶
"Installing the cross bar" on page
81.
▶
"Installing the fan cage" on page 76.
▶
"Installing the air duct" on page 79.
▶
Install all riser modules, see "Installing a riser module" on page 72.
▶
"Reassembling" on page 60.
▶
If applicable, install the OCP module, see "Installing an OCP module" on
page 249.
▶
Install all PSUs, see "Installing a hot-plug PSU" on page 124.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 69.
▶
If applicable, "Installing the front cover with lock" on page 69.
▶
"Resuming BitLocker functionality" on page 105.
System board and components
490 Upgrade and Maintenance Manual RX2540 M6
To Next Page
Loading...
