Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Figure 16: Connecting the server to the DC voltage - example DC PSU -48 V
▶
Connect the power cord to the PSU (1).
▶
Fasten the two studs (2).
▶
Ensure that the status indicator on the PSU is lit green, see "Indicator on
hot-plug PSU" on page
565
.
▶
If necessary, make a permanent connection to the distribution board.
CAUTION
If the server/rack is intended for permanent connection to the mains only
an authorized specialist (electrician) is allowed to work.
▶
Please follow the regulation of each country.
It will take about 60 seconds until the server can be switched on.
Basic hardware procedures
RX2540 M6 Upgrade and Maintenance Manual 67

Fujitsu PRIMERGY RX2540 M6 Specifications

General

Memory Slots	32 DIMM slots
Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (3rd generation)
Storage	Up to 24 x 2.5" or 12 x 3.5" drives
RAID Support	RAID 0, 1, 5, 6, 10
Network	4 x 1GbE ports (onboard), optional 10/25GbE
Power Supply	800 W, 1200 W, 1600 W
Expansion Slots	Up to 8x PCIe Gen4 slots
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Management	iRMC S5