Example HVDC PSU 380 V
CAUTION
The HVDC PSU adjusts automatically to any mains voltage in the range
from 200 V – 380 V.
▶
Y
ou may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Figure 17: Connecting the server to the DC voltage - example HVDC PSU 380 V
▶
Push the power cord plug into the PSU connector until it clicks in. The nose
of the power cord plug (A) engages in the recess of the PSU connector (B).
▶
Ensure that the status indicator on the PSU is lit green, see "Indicator on
hot-plug PSU" on page 565
.
▶
If necessary, make a permanent connection to the distribution board.
CAUTION
If the server/rack is intended for permanent connection to the mains
only an authorized specialist (electrician) is allowed to work.
▶
Please follow the regulation of each country.
It will take about 60 seconds until the server can be switched on.
Basic hardware procedures
68 Upgrade and Maintenance Manual RX2540 M6
To Next Page
Loading...
