239
Masterpiece
User Manual
In the Macro Assign menu, touch the saved macro file in the table and press the {Attach}
button, this will make the macro ready to attach. Finally, touch one of the free OLED button the
Masterpiece control surface and the macro is attached. If you touch the OLED button the
macro with the “Squeeze” effect will run.
For memory file 102, that takes the system back to normal. Once again touch the DMEM
memory file ready to touch the DMEM {Load} button, then touch the {Macro Record} button.
Touch the {Load} button and when the DMEM has loaded, touch the {Macro Record} button to
stop the macro from running.
In the Macro Edit menu, test the macro to make sure that it works as required, then save the
macro and attach the macro to an OLED button as just described.
The two macros attached to the OLED buttons will now have the squeeze effect action on one
button and the back to normal action on the other.
To Next Page
Loading...
