EasyManuals Logo

Honeywell SmartPAC 2 User Manual

Honeywell SmartPAC 2
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
1126800 SmartPAC 2 with WPC Integration
Page 108 Chapter 2 Installing SmartPAC 2 and WPC
Prepare to Determine Top Stop Angle
1. Make sure there is no connection to pin 13 on the WPC board. This ensures that Top
Stop in Inch is ENABLED.
2. On SmartPAC 2, go to Initialization mode (page 203). Select PRESS CONTROL. Select
PRESS OPTIONS. Make sure switches 1, 2 and 4 are set to OPEN. To change the switch
setting, highlight it and press ENTER to toggle between OPEN and CLOSED. For more
information about the switches, see “Setting Switches,” page 242.
3. Power down the SmartPAC 2 and power it up again to make the new switch settings take
effect.
4. If your WPC has Micro-inch, disable this feature by setting the Micro-inch angle to 185°
(see page 236).
5. Set the Stroke Select keyswitch to INCH.
6. If yours is a variable speed press, set the speed to the slowest production speed, but not
less than 6 SPM.
Go to the next section.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell SmartPAC 2 and is the answer not in the manual?

Honeywell SmartPAC 2 Specifications

General IconGeneral
BrandHoneywell
ModelSmartPAC 2
CategoryControl Unit
LanguageEnglish

Related product manuals