NTP-015: Circuit Order 365-575-102
Page2of6 Issue8.0,July2002
2. Determine whether the identified “Protection
quad” is already equipped. At the CIT, select
CONFIGURATION-Retrieve-Equipment and
execute to obtain a report showing how the shelf
is currently equipped.
—
3. From the report, is the protection quad equipped
with an existing circuit pack?
NOTE:
If the report indicates a circuit pack is
present but no circuit pack is installed,
perform CONFIGURATION-Update
command.
If NO, then go to Step 13.
If YES, then continue with Step 4.
—
4. Are the protection quad’s slot/slots already
equipped with an optical pack?
If NO, then go to Step 9.
If YES, then continue with Step 5.
—
5. Is the quad already equipped with an OC-12
circuit pack?
If NO, then go to Step 15.
If YES, then continue with Step 6.
—
6. Are fibers already terminated on the OC-12
circuit pack?
If NO, then it is available, go to Step 13.
If YES, then continue with Step 7.
—
7. Determine whether the quad already has
cross-connects defined. At the CIT, select the
CONFIGURATION-Retrieve-Crossconnect
ion-All command for this slot.
—
DOITEMSBELOWINORDERLISTED........ FORDETAILS,GOTO
To Next Page
Loading...
Need help?
General