Lucent Technologies FT-2000 OC-48 - Example 36 - PERFORMANCE-Retrieve-PM Threshold-Line

Craft Interface Terminal Usage
Issue 8.0 July 2002
11-115
Example 36 - PERFORMANCE-Retrieve-PM Threshold-Line 11
Releases 7 and Later (Use the PERFORMANCE category.)
The report shows the current performance-monitoring threshold crossing alert
(TCA) values for the OC-48 lines. This report is not available at the repeater site.
Address - Shows the specific OC-48 line.
Bin - Shows the quarter-hour (QH) and day bins.
BER - Shows the provisioned bit error rate; for example, -9 is 10
-9
,
for the QH bin and Day bin.
CV-L - Shows the number of line code violations reported during
the specified time that exceeded the BER setting.
ES-L - Shows the provisioned number of line errored seconds for
the QH bin and the Day bin that will cause a TCA.
SES-L - Shows the provisioned number of line severely errored
seconds for the QH bin and the Day bin that will cause a
TCA.
UAS-L - Shows the provisioned number of unavailable seconds for
the QH bin and the Day bin that will cause a TCA.
TCA Report - Shows if the automatic reporting of TCAs is enabled or
disabled.
Delta-1 93-01-15 13:15:15 EST
M Retrieve-PM Threshold-Line:OC48:All: COMPLD
/* OC-48 Line Performance Monitoring Threshold Value Report
===========================================================================
--------- OC-48 Line (B2) ----------
Address Bin BER CV-L ES-L SES-L UAS-L
===========================================================================
line-1e QH -9 9000 25 10 10
Day -9 9000 250 10 10
line-1w QH -9 9000 25 10 10
Day -9 9000 250 10 10
*/
;
/* OC-48 Line TCA Autonomous Reporting Status Report
===========================================================================
--------- OC-48 Line (B2) ----------
TCA Report TCA Report TCA Report TCA Report TCA Report
Address Bin BER CV ES SES UAS
===========================================================================
line-1e QH Enable Enable Disable Disable Disable
Day Enable Enable Disable Disable Disable
line-1w QH Enable Enable Disable Disable Disable
Day Enable Enable Disable Disable Disable
*/