Maintenance Description
Issue 8.0 July 2002
9-95
designation at the node where the request was entered, and a "fe" (far end)
designation at the other end of the line. If the same priority request was
entered at both ends of a line, both ends show "ne."
â– Deferred switch priority: This shows the priority of any pending switch
request for a circuit pack or external DS1 reference.
For more information, refer to the FAULT-Retrieve-State input in Volume I,
Section 11, "Craft Interface Terminal Usage."
Version/Equipment List 9
The version/equipment list report is an on-demand report that lists the circuit pack
version and the software release (if applicable) for the FT-2000 OC-48
Add/Drop-Rings Terminal and FT-2000 OC-48 Repeater Bay. This report also lists
all the circuit packs that are present. For more information, refer to the
CONFIGURATION-Retrieve-Equipment input in Volume I, Section 11, "Craft
Interface Terminal Usage."
Synchronization Report 9
The synchronization report is an on-demand report that lists the status of the
system synchronization at the FT-2000 OC-48 Add/Drop-Rings Terminal. This
report lists all the clock parameters that can be interrogated from a craft interface
terminal or from remote telemetry. For more information, refer to the
CONFIGURATION-Retrieve-Synchronization input in Volume I, Section 11,
"Craft Interface Terminal Usage."
To Next Page
Loading...
Need help?
General