Administration and Provisioning
Issue 8.0 July 2002
8-93
Deleting OC-12 Data Communications Channel Assignments 8
The OC-12 DCC assignments shown in Figure 8-28 may be deleted using the
CONFIGURATION-Delete-Assignment-DCC input.
â– At CO 1, an OC-12 DCC assignment is deleted by specifying:
— low-speed interface slot (slot 1B)
— DCC (channel 3).
â– At CO 2, an OC-12 DCC assignment is deleted by specifying:
— low-speed interface slot (slot 3B)
— DCC (channel 6).
For more information about deleting OC-12 DCC assignments at an FT-2000
OC-48 Add/Drop-Rings Terminal, refer to the Operation Task Index in the
"Operation and Maintenance (TOP)" section (Volume II).
Access Identifiers 8
The access identifiers (AIDs) are used to access the functionality of the FT-2000
OC-48 Lightwave System. The FT-2000 OC-48 Lightwave System also uses AIDs
to identify, address, and report on entities within the system. Entities are circuit
pack slots, ports, signals, transmission lines, operations interfaces, data
communications channels (DCC), and alarm interfaces.
The following tables provide the AIDs used by the FT-2000 OC-48 Lightwave
System:
FT-2000 OC-48 Add/Drop-Rings Terminal Input Values Table 8-1
FT-2000 OC-48 Add/Drop-Rings Terminal Output Values Table 8-2
FT-2000 OC-48 Repeater Bay Input Values Table 8-3
FT-2000 OC-48 Repeater Bay Output Values Table 8-4
To Next Page
Loading...
Need help?
General