Craft Interface Terminal Usage
11-52 Issue 8.0 July 2002
Example 9 - CONFIGURATION-Retrieve-Crossconnection-STS1 11
Release 7.0.1
The above report shows information on the add/drop/through configuration of an
FT-2000 Add/Drop Rings Terminal. If no cross-connections are found, the
heading of this report will print, followed by the message:
NOTICE: No cross-connections exist.
/* STS-1 Cross-Connection Map Report
*: = Invalid Flag
+: = AUDIT parameter Flag
==============================================================================
Source Destination Source Destination Primary
AID AID Type TID TID State
==============================================================================
1e-1-1 1w-1-1 2WAY Chicopee-MA Worcester-MA
ls-4a-3 1e-1-2 2WAY Chicopee-MA
1w-1-2 ls-2b-1 1WAY Worcester-MA
ls-5a-1 1w-2-1 1WAY West-Ossipee-NH ACT
ls-5b-1 lw-2-1 1WAY West-Ossipee-NH STBY
1w-2-1 ls-5a-1 1WAY West-Ossipee-NH
1w-2-1 ls-5b-2 1WAY West-Ossipee-NH
1e-3-2 1w-3-2 2WAY Lenox-MA Quabbin-MA
1e-4-1 1w-4-1 1WAYDRI Keene-NH Boscawen-NH STBY
ls-6a-1 lw-4-1 1WAYDRI Boscawen-NH ACT
1w-4-3 1e-4-3 1WAY Boscawen-NH Keene-NH
1w-4-1 ls-6a-2 1WAY Boscawen-NH
1e-5-3 1w-5-3 2WAY Suncook-NH Jamaica-VT
1w-5-1 ls-4a-1 1WAY Jamaica-VT
1e-6-2 1w-6-2 1WAY Pittsfield-MA Quabbin-MA
1w-7-1 ls-8b-2 2WAY *Goffstown-NH
1e-7-1 ls-6a-3 2WAY Alfred-ME
1e-7-1 ls-4b-1 1WAY Suncook-NH
*/
To Next Page
Loading...
Need help?
General