365-575-102 Operation:
Issue 8.0, July 2002 Page 1 of 4
NTP-002
Install Software (Initial Installation/Upgrade/Change)
into CIT and FT-2000 Network Element
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO
1. Required Test Equipment:
Craft Interface Terminal (CIT)
Wrist Strap
!
CAUTION:
When installing software, the CIT-PC software must be the same
release or a higher release than the software currently running in the
FT-2000 network element.
!
CAUTION:
All network elements within a particular network must be running the
same software release. The CIT-PC software must be the same
release as the network elements or a higher release.
NOTE:
Disks available include the 5-1/2 inch (1.2M-byte) floppy, the 3-1/2
inch (720k-byte) floppy, or CD-ROM.
NOTE:
For a general description on using a personal computer in the
following procedures, refer to DLP-529.
Verify the software disks or CD-ROM con-
sists of INSTALL DISK, CIT-PC DISK,
GENERIC and DATA numbered disks, and
the appropriate documentation as follows:
—
To Next Page
Loading...
Need help?
General