365-575-102 Trouble Clearing: TAP-115
Issue 8.0, July 2002 Page 3 of 8
Sync Mode Auto Switch or Sync Reference Auto Switch Conditions
14. Is there one or more other conditions with the same Source Address in the
report?
NOTE:
Conditions are shown in the Description column of the Active Alarm and
Status Report.
If YES, then continue with Step 15.
If NO, then consult the appropriate maintenance support organization for
further technical assistance.
15. Identify the topmost other condition in the report with the same Source
Address. Find this condition in Table A of TAP-102 and go to the referenced
TAP.
16. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
Line Auto Switch Condition
NOTE:
The failure to be cleared is a line auto switch condition.
17. Is there one or more other conditions with the same line Source Address in
the report?
NOTE:
Conditions are shown in the Description column of the Active Alarms
and Status Report.
If YES, then continue with Step 18.
If NO, then continue with Step 20.
NOTE:
While following the instructions in the procedure(s) to which you will now be
sent, you MUST ignore the line auto switch condition in the Active Alarms
and Status Report. For example, if you are asked whether there are any alarm
or status conditions listed and the only condition shown in the report is line
auto switch, the answer is NO.
To Next Page
Loading...
Need help?
General