365-575-102 TroubleClearing:
Issue 8.0, July 2002 Page 1 of 2
TAP-117
Clear ‘Excessive Holdover’
NOTE:
Another condition is affecting the synchronization of the FT-2000. This condition
is causing the FT-2000 to operate in a synchronization holdover mode for an
excessive amount of time.
1. Refer to the Description column of an Active Alarms and Status Report and
find another condition (not excessive holdover) affecting synchronization
in the FT-2000.
2. Find this second condition (identified in Step 1) in Table A of TAP-102 and go
to the referenced TAP.
3. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General