365-575-102 TroubleClearing:
Issue 8.0, July 2002 Page 1 of 2
TAP-130
Clear ‘Site Provisioning Conflict’
1. Is this a point-to-point network or a ring network?
If point-to-point network, then continue with Step 2.
If ring network, then continue with Step 6.
2. Determine from office records which FT-2000 end terminal is to be "Site 0."
NOTE:
In an FT-2000 point-to-point network, one and only one of the two
FT-2000 end terminals must be provisioned to be "Site 0."
3. At each FT-2000 end terminal, obtain a report as follows: at the CIT, select
SECURITY-Retrieve-Network Element and execute. Determine the
value (either yes or no) of the Site 0 parameter.
4. At the incorrectly provisioned FT-2000 end terminal and at the CIT, select
SECURITY-Set-Network Element and execute to change the Site 0
parameter to the correct value.
5. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
6. Check the OC-48 optical connections to the adjacent nodes in both directions
to verify that the East (West) TRMTR here is connected to the West (East)
RCVR there and that the East (West) RCVR here is connected to the West
(East) TRMTR there. Rearrange any incorrect connections.
NOTE:
A likely cause of a site provisioning conflict condition is that the East
(West) TRMTR at one node is connected to the East (West) RCVR at the
next node.
7. At the CIT, select FAULT-Retrieve-Alarm (and Status) to obtain
another Active Alarms and Status Report.
8. Does the site provisioning conflict condition still appear in the
report?
If YES, then continue with Step 9.
If NO, then STOP! YOU HAVE COMPLETED THIS PROCEDURE.
9. Consult the appropriate maintenance support organization for further technical
assistance.
10. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General