TAP-153: Trouble Clearing 365-575-102
Page2of2 Issue8.0,July2002
3. Consult office records to determine the proper TID and/or NID for the
Source/Destination of the troublesome cross-connection (*TID).
4. Is the TID/NID from the report (Step 2) the same as that specified in the office
records (Step 3).
If YES, then continue with Step 5.
If NO, then continue with Step 8.
5. Log in to the node with the incorrect TID/NID. If a remote login is required and
you need additional help, refer to DLP-524.
6. At the CIT, select the SECURITY-Set-Network Element command and
execute to correct the TID and/or NID.
7. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
8. Is the Source/Destination node of the troublesome cross-connection from a
node that has been deleted?
If YES, then continue with Step 9.
If NO, then continue with Step 13.
9. Consult office records and verify that the cross-connection is no longer
needed.
10. Identify the nodes with the incorrect cross-connections and log in to the nodes
one at a time.
11. At the CIT, select the CONFIGURATION-Delete-Crossconnection-STS3
(or STS1) command and execute to delete the cross-connections for the
deleted node.
12. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
13. Consult office records to determine the correct TID/NID for the Source/Desti-
nation of the troublesome cross-connection (*TID).
14. At the CIT, select the CONFIGURATION-Enter-Crossconnection-STS3
(or STS1) command and correct the Source/Destination for each of the
cross-connections with an asterisk in the STS-3 (or STS-1) Cross-Connection
Map Report.
15. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General