365-575-102 DetailedLevelProcedure:
Issue 8.0, July 2002 Page 1 of 2
DLP-516
Obtain State Report
Overview: This procedure supports obtaining the appropriate report after the
provisioning of a DS3, EC1, OC-3, or OC-12 slot or port.
1. At the CIT, select CONFIGURATION-Retrieve and the appropriate modifiers
as shown in Table A to obtain a State Report based on the previous parameter
selections (provisioning).
2. Press function key F9 to execute and to display the report.
3. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
Table A - Parameter
If Slot and Port Parameter
Selections Were
Select These Inputs (Commands) to
Obtain Report
CONFIGURATION-Set-Low Speed CONFIGURATION-Retrieve-Low
Speed:All
CONFIGURATION-Set-T3 CONFIGURATION-Retrieve-T3:All
CONFIGURATION-Set-State-T3 CONFIGURATION-Retrieve-T3:All
CONFIGURATION-Set-EC1 CONFIGURATION-Retrieve-EC1:All
CONFIGURATION-Set-State-EC1 CONFIGURATION-Retrieve-EC1:All
CONFIGURATION-Set-OC3 CONFIGURATION-Retrieve-OC3:All
CONFIGURATION-Set-State-OC3 CONFIGURATION-Retrieve-OC3:All
CONFIGURATION-Set-OC12 CONFIGURATION-Retrieve-OC12:All
CONFIGURATION-Set-state-OC12 CONFIGURATION-Retrieve-OC12:All
To Next Page
Loading...
Need help?
General