Operations Interfaces
6-6 Issue 8.0 July 2002
message set as the message-based operations system interface (X.25/TL1). In
Release 5 and later releases, the TL1 message set consists of maintenance
commands (excludes autonomous messages) and cannot be used to install
software in an FT-2000 OC-48 Add/Drop-Rings Terminal. On-line help messages
are not supported.
The CPro-2000 Graphical User Interface and Provisioning Tool simplifies and
mechanizes operations of transmission network elements. It provides a common
look and feel across the SONET subsystem of FT-2000, DDM-2000 OC-3
Multiplexer and the
SLC
â
-2000
Access System.
A PC must meet the following minimum requirements to be loaded with the
CPro-2000 software and used as a CIT:
386SX
IBM
compatible computer (desktop or lap top) (25 MHz or greater
clock)
n Disk drive — one 1.44 megabytes (3.5 inches)
n Hard disk with approximately 5 megabytes of free space
n 8 megabyte RAM
*
n
MS-DOS
computer program, Version 5.0 or later
n
Windows
computer program, Version 3.1
n Serial port (EIA-232-D) — configured as COM1 or COM2
n Mouse
n VGA color monitor.
The CPro-2000 Graphical User Interface and Provisioning Tool has been tested
with
NCR
†
,
NEC
‡
, and
Gateway-2000
§
personal computers. The CPro-2000
Graphical User Interface and Provisioning Tool has also been tested with a
SUN
¶
SPARC
**
station 10 workstation that has a SUNPC3.1 software environment set
up on a PC emulator hardware and running windows in the enhanced mode. For
more information about the CPro-2000 Graphical User Interface and Provisioning
Tool, refer to 190-523-101,
Guide to Using CPro-2000
.
* No memory resident programs running in the background.
† Trademark of NCR Corporation.
‡ Registered trademark of Nippon Denki Kabushiki Kaisha.
§ Registered trademark of Gateway 2000, Inc.
¶ Registered trademark of SUN Microsystems Inc.
** Registered trademark of SPARC International, Inc., licensed exclusively to SUN
Microsystems Inc.
To Next Page
Loading...