To Next Page

To Previous Page

Administration and Provisioning

Issue 8.0 July 2002

8-3

Before Release 4, when a SYSMEM unrecognizable code or

SYSMEM/SYSCTL code mismatch condition was active after replacing a

SYSMEM circuit pack, all LNCTL and OHCTL circuit pack functions were stopped

(no protection switching and condition reporting), and the FAULT LEDs on these

circuit packs were lighted. In Release 4 and later releases, the LNTCL and

OHCTL circuit pack functions are not stopped when a SYSMEM unrecognizable

code or SYSMEM/SYSCTL code mismatch condition is active after replacing a

SYSMEM circuit pack.

The FT-2000 OC-48 Lightwave System supports the following CIT memory

administration functions:

■ Install-Software: This copies the executable code and original values from

floppy disks in the CIT to the SYSMEM circuit pack. Refer to the

Install-Software function in the "Operation" Tab of this manual.

■ Initialize-System: The CONFIGURATION-Initialize-System input

replaces most current values in the SYSMEM circuit pack with the original

values in the SYSMEM circuit pack and initiates the reset function (see

Reset). All cross-connections, loopbacks, and switch states are retained.

However, 1+1 protection switch states are not retained. Automatically

provisioned parameters are unaffected by this command. The current

values that are not replaced with their original values are those set with the

following inputs:

— CONFIGURATION-Set-Date

— SECURITY-Set-Password

— SECURITY-Set-Login

— SECURITY-Set-Security

— SECURITY-Set-Far End Communications

— SECURITY-Set-Network Element

■ Reset: The FAULT-Reset input copies the current values from the

SYSCTL circuit pack to the SYSMEM circuit pack and the executable code

from the SYSMEM circuit pack to the SYSCTL circuit pack. The executable

code in the SYSCTL circuit pack is then restarted and the current values in

the SYSMEM circuit pack are reformatted to work with the new executable

code.

■ Update: The CONFIGURATION-Update input updates the state of all the

automatically provisioned parameters based on what circuit packs are

present and the condition of the incoming signals. Refer to "Provisionable

Parameters and Original Values" in this section for more information about

automatically provisioned parameters.

Lucent Technologies FT-2000 OC-48 User Manual

Questions and Answers: