Administration and Provisioning
Issue 8.0 July 2002
8-65
■ At node 2 (primary node), a 1-way-DRI cross-connection is entered by
specifying:
— Source low-speed interface slot
*
(slot 5A)
— Destination line (line 1W)
— Destination STS-3 tributary (tributary 6)
— Destination node TID
†‡
(node 0 TID).
— Secondary node TID
†
(node 3 TID).
■ At node 3 (secondary node), a 1-way add cross-connection is entered by
specifying:
— Source (slot)
— Source low-speed interface slot* (slot 4B)
— Destination line (line 1W)
— Destination STS-3 tributary (tributary 6)
— Destination node TID
†‡
(node 0 TID).
■ At node 1, a 1-way through cross-connection is entered by specifying:
— Source (tributary)
— Source line (line 1E)
— Source STS-3 tributary (tributary 6)
— Source node TID
†
(node 3 TID)
— Destination (tributary)
— Destination node TID
†‡
(node 0 TID).
■ At node 0, a 1-way drop cross-connection is entered by specifying:
— Source (tributary)
— Source line (line 1E)
— Source STS-3 tributary (tributary 6)
— Source node TID† (node 3 TID)
— Destination (slot)
— Destination low-speed interface slot
*
(slot 2B).
* If the specified slot is part of a slot pair (for example, slot 1A and 1B) that has been
provisioned for the OC-3 1+1 protected mode, specifying one slot also includes the
companion slot. The same type of logic applies to OC-12 1+1 protected mode.
† Entering a question mark (?) in response to the TID prompt will display a point-and-shoot
list of available addresses in the OC-48 ring. Enter the Retrieve-Map-Ring command
to update the point-and-shoot list.
‡ If an STS-3 tributary is bridged at one or more nodes in a ring, the last node where the
low-speed signals are terminated must be specified as the destination node.
To Next Page
Loading...