Administration and Provisioning
8-76 Issue 8.0 July 2002
■ At node 1, the 1-way through cross-connection is deleted by specifying:
— Source (tributary)
— Source line (line 1W)
— Source STS-3 tributary (tributary 6)
— Source STS-1 tributary (tributary 1)
— Destination (tributary).
The 1-way drop cross-connection is deleted by specifying:
— Source (tributary)
— Source line (line 1W)
— Source STS-3 tributary (tributary 6)
— Source STS-1 tributary (tributary 1)
— Destination (STS-1 Port)
— Destination low-speed interface slot
*
(slot 4A)
— Destination low-speed port (1).
■ At node 2, the 1-way drop cross-connection is deleted by specifying:
— Source (tributary)
— Source line (line 1W)
— Source STS-3 tributary (tributary 6)
— Source STS-1 tributary (tributary 1)
— Destination (STS-1 port)
— Destination low-speed interface slot
*
(slot 5A)
— Destination low-speed port (1).
■ The 2-way add/drop cross-connection is deleted by specifying:
— Source (STS-1 port)
— Source low-speed interface slot
*
(slot 2A)
— Source low-speed port (3)
— Destination line (line 1E)
— Destination STS-3 tributary (tributary 5)
— Destination STS-1 tributary (tributary 2).
* If the specified slot is part of a slot pair (for example, slot 1A and 1B) that has been
provisioned for the OC-3 1+1 (Release 5 or later releases) protection mode, specifying one
slot also includes the companion slot. The same type of logic applies to OC-12 1+1
(Release 7.1or later releases) protected mode.
To Next Page
Loading...